Configure an IS-IS Accept Policy to Apply for a Specific I-SID

Configure an IS-IS accept policy for a specific I-SID number to represent a local or remote Layer 3 VSN, which allows the system to redistribute the remote VSN to the VSN where you applied the filter. An I-SID value of 0 represents the global routing table (GRT).

Note

Note

If the route policy changes, you must re-apply the IS-IS accept policy, unless it was the last sequence in the configuration.

Before you begin

  • Enable IS-IS globally.

  • Ensure the manual area exists.

  • You must configure a route-map to apply.

Procedure

  1. In the navigation pane, expand Configuration > IP.
  2. Select IS-IS.
  3. Select the Accept Isid tab.
  4. Select Insert.
  5. In the Isid field, specify the SPBM nickname.
  6. Select enable in the Enable check box to enable the filter.
  7. In the PolicyName field, specify the route-map name.
  8. Select Insert.

Accept Isid Field Descriptions

Use the data in the following table to use the Accept Isid tab.

Name

Description

Isid

Configures a specific I-SID number to represent a local or remote Layer 3 VSN to which the IS-IS accept policy applies.

Based on the routing policy the system applies, the system redistributes the remote VSN to the VSN where you applied the filter.

An I-SID value of 0 represents the global routing table (GRT).

Enable

Enables or disables the I-SID entry. You must enable the value to filter. The default is disabled.

PolicyName

Specifies the route map name. You must configure a policy earlier in a separate procedure.

BackbonePolicyName

Specifies the backbone route map name. You must configure a policy earlier in a separate procedure.